Stern: Berzerk hardware

The same hardware used by Berzerk was also used in the sequel, Frenzy. The only difference I believe was the ROM boards. However, there is a conversion document available on the web to run both Frenzy and Berzerk. See the link below.


Link to Berzerk/Frenzy conversion information

Running Berzerk/Frenzy on a Switching Power Supply

From Doug Jeffries:
If you're running Berzerk or Frenzy on a switching power supply, you have to jumper diode CR26 (near the battery) to convince it to power up.

If you've done this already, and the game is still not powering up, there is something else wrong with your set up.

Back to Stern
Back to Troubleshooting
Back to M.A.R.S.